These are installation instructions for Bash.
The configure
shell script attempts to guess correct
values for various system-dependent variables used during
compilation. It uses those values to create a `Makefile' in
each directory of the package (the top directory, the
`builtins' and `doc' directories, and the
each directory under `lib'). It also creates a
`config.h' file containing system-dependent definitions.
Finally, it creates a shell script named config.status
that you
can run in the future to recreate the current configuration, a
file `config.cache' that saves the results of its tests to
speed up reconfiguring, and a file `config.log' containing
compiler output (useful mainly for debugging configure
).
If at some point
`config.cache' contains results you don't want to keep, you
may remove or edit it.
If you need to do unusual things to compile Bash, please
try to figure out how configure
could check whether or not
to do them, and mail diffs or instructions to
bash-maintainers@gnu.org so they can be
considered for the next release.
The file `configure.in' is used to create configure
by a program called Autoconf. You only need
`configure.in' if you want to change it or regenerate
configure
using a newer version of Autoconf. If
you do this, make sure you are using Autoconf version 2.10 or
newer.
If you need to change `configure.in' or regenerate
configure
, you will need to create two files:
`_distribution' and `_patchlevel'. `_distribution'
should contain the major and minor version numbers of the Bash
distribution, for example `2.01'. `_patchlevel' should
contain the patch level of the Bash distribution, `0' for
example. The script `support/mkconffiles' has been provided
to automate the creation of these files.
The simplest way to compile Bash is:
cd
to the directory containing the source code and type
`./configure' to configure Bash for your system. If you're
using csh
on an old version of System V, you might need to
type `sh ./configure' instead to prevent csh
from trying
to execute configure
itself.
Running configure
takes awhile. While running, it prints some
messages telling which features it is checking for.
bashbug
bug
reporting script.
bash
and bashbug
.
This will also install the manual pages and Info file.
You can remove the program binaries and object files from the
source code directory by typing `make clean'. To also remove the
files that configure
created (so you can compile Bash for
a different kind of computer), type `make distclean'.
Go to the first, previous, next, last section, table of contents.